9 Appliance Preparation
A. Top Vent | • Fold the center parts of the retaining band up and use |
CAUTION! Risk of Cuts, Abrasions or Flying Debris. | to remove the vent cap. |
| |
Wear protective gloves and safety glasses during installa- |
|
tion. Sheet metal edges are sharp. |
|
NOTICE: Once appliance is set up for top or rear venting, |
|
it CANNOT be changed at a later time. |
|
• Remove the cover plate by removing the four screws |
|
holding it to the top of the appliance. Remove and discard |
|
the cover plate. |
|
|
|
Figure 9.1
•Remove the center insulation plug.
Figure 9.2
•Cut the metal retaining band and fold the sides out.
Figure 9.4
•Discard the vent cap, remove and discard the insulation basket.
Note: Once the vent cap has been removed it cannot be reattached.
Figure 9.5
•Snap the first vent section into place.
Figure 9.3
38 | Heatilator • Evolution • |
