High End Systems SHOWGUN Flag Calibration Example, Reattach the retaining clips on the lens shaft

CHAPTER 5

Maintenance and Troubleshooting

5.Push the lens into the fixture

6.Reattach the retaining clips on the lens shaft.

Flag Calibration Example

This example shows you how to recalibrate the dimmer flags:

Connect dimmer flag motors directly to 2-phase driver

1.Detach header from motors powering the two DIM flags on the Lower bulk head.

2.Remove the two M4 socket caps and slide the Lower bulk head out of the fixture.

3.Loosen two captive screws to remove electronic housing cover over the display panel and take out the two service harnesses located on the back side of the display panel.

4.Locate the 2-phase board that controls the dimmer motors. Disconnect the M1 and M2 for the two DIM flags on Board 2 (the lower front board of the 4-board bracket inside the fixture.

46 SHOWGUN® User Manual