First time use

Front/Rear/Side Panel Controls

POWER light indicator

To turn the monitor ON, press the main power switch located on the lower right side of the monitor. A red stand-by indicator lamp located on the lower right corner of the front bezel will illuminate. The Plasma TV is now ready for remote ON/OFF operation.

 

 

 

 

 

 

Indicating Lamp

Power Status

Operating

 

 

 

 

 

 

 

Off

Off

When the main power switch is set to

 

 

 

 

OFF.

 

 

 

 

 

 

 

Lights Red

Off

When the main power switch on the display

 

 

 

(Stand-by)

monitor is ON.

 

 

 

 

 

 

 

Lights Green

On

Display monitor MAIN POWER is ON.

 

 

 

 

 

 

 

Lights Orange

Off

Display monitor MAIN POWER is ON

 

 

 

(Power Saving)

with no signal input except antenna

 

 

 

 

(no sync. signal).

 

 

 

 

 

 

 

 

 

 

 

REMOTE CONTROL sensor

Point your remote at this area when selecting channels, adjusting volume, etc.

LEARNING AV NET sensor

Point your equipment’s remote control at this area while using the AV NET Learning Wizard.

SIDE INPUT JACKS (for VIDEO: 5)

Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording. Press the INPUTS button then use the CURSOR PAD and the SELECT button on the remote control to select INPUT 5. If you have mono sound, insert the audio cable into the left audio jack.

IEEE1394 (DV Input)

This input provides a digital interface for your external digital devices such as your digital video (DV) camcorder.

NOTES: 1. Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input when VIDEO: 1, 2, 3, 4 and 5. Check the Power Light to make sure the Display Monitor is turned off or in Stand-by mode (lights red) when not in use.

2.Remote Control can not turn ON/OFF the “MAIN POWER” of the display monitor.

10

Page 10
Image 10
Hitachi 55HDT52 Power light indicator, Remote Control sensor, Learning AV NET sensor, Side Input Jacks for Video