Setup
Lamp Power Control
Use this feature to have the TV turned OFF automatically when a video signal is not detected for 15 minutes.
1. Press the CURSOR PAD or to highlight Yes or No.
or
Setup
Menu Preference
Lamp Power Control
Set The Inputs
Set AV NET
Set Closed Captions
Set Monitor Out
Upgrades
Quick Start Up
Move | SEL Set |
Setup
Lamp Power Control
Automatic Power Saving Yes 
No
Select yes to have the TV turn off automatically when a video signal is not detected for 15 minutes
Move SEL Return
NOTE: Your new HDTV has a
INSTRUCTIONS:
1.Access the Menu OSD by press the MENU button of the remote control.
2.Navigate the menu to access SETUP, then LAMP POWER CONTROL. SET AUTO POWER SAVING OFF (No) using the Cursor and the SELECT buttons of the remote control.
3.Use the Cursor buttons to highlight “No” then press the SELECT button to set this feature to Off.
4.After CableCARD set up is completed, set the Auto Power Saving feature to ON (Yes).
On-Screen
Set The Inputs
Use this feature to give a name to any of the five video inputs. A named input is shown in the INPUTS menu.
1. Press the CURSOR PAD , , or to highlight the name of the video inputs.
2.Select from one of the following choices to set an input name:
A/V Receiver, DVD, DVD2, VCR, VCR2,
Cable (STB), Satellite, PVR, DVD Recorder,
CAM, LB, Gray out (Skip), Hide (Skip)
or
Note: The inputs labeled Gray out (Skip) or Hide (Skip) are disabled in the INPUTS selection.
Setup
Menu Preference
Lamp Power Control
Set The Inputs
Set AV NET
Set Closed Captions
Set Monitor Out
Upgrades
Quick Start Up
Move | SEL Set |
Setup
Lamp Power Control
Automatic Power Saving Yes 
No
Select yes to have the TV turn off automatically when a video signal is not detected for 15 minutes
Display
Move SEL Return
75
