Washing in Your Favorite Way
按照您喜歡的方式進行洗衣
■Any of the processes of "Washing", "Rinsing" and "Spinning" can be set up alone, and the processes can also operate in combination. (The content of the washing will not be stored)
可以單獨設定洗衣、沖洗、脫水任何一個程序，亦可將各個程序組合運轉。(洗衣內容將不會被儲存)
Attention 注意
•Except the "washing → rinsing → spinning" and "washing → spinning", when other washing modes are set, no stirring of the washings will be made for loosening clothes after the completion of drainage.
除“洗衣→沖洗→脫水”及“洗衣→脫水”設定外，設定其他洗衣方式時，最後排水結束後不會為疏鬆衣物而進行理衣攪拌。
In the following cases
在下列情況下
Wash in the favorite way
按自己喜歡的方式洗衣時
Washing→Rinsing→Spinning洗衣→沖洗→脫水
Use the detergent again
再次使用洗衣液時
Washing only單洗
No need spinning after rinsing
漂水結束後無需脫水時
Washing→Rinsing洗衣→沖洗
To rinse the washed laundry 希望將已洗過的衣物沖洗時
Rinsing only只沖洗
To rinse and spin the washed laundry
希望將已洗過的衣物沖洗並脫水時
Rinsing→Spinning沖洗→脫水
To drain the water out of the washing basket or to spin before drying
希望排出洗衣槽內的水或在晾乾前脫水
Draining only, spinning only只排水，只脫水
電源
Press the | Select the |
| power button | "NORMAL" process |
按下電源開關 | 選擇“標準”程序 |
Select the water level
選擇水位
The sensor will fix the water level automatically in the case of no set to water level.
沒有設定水位時， 由傳感器自動決定 水位多少。
Select the water level
選擇水位
Automatically set to "60 L" in the case of no set to water level.
沒有設定水位時，自
動設定為『60L』。
set to"58L".
Set washing modes by pressing the buttons
通過各按鈕設定洗衣 方式
After draining and spinning, it begins to add water for rinsing.
排水和脫水結束 後，開始供水準 備沖洗。
Select spinning "1 min." when draining only.
只排水時，請選擇脫水“1分 鐘”進行運轉。
38
