AIR-JET Process (continued)
風乾程序(續)
Air-jet Process
風乾方法
Take out the laundries after washing process, rearrange them evenly and them put them into the washing basket.
洗衣結束後,取出衣物,理順後將其平整放入洗衣槽。
•The
按下電源開關按鈕 。
Attention 注意
•Please never forget to use the nanometer titanium
filter net. 45
請務必使用納米鈦淨化網。 45Press the按下『 風乾』按鈕 ,設定風乾時間。
■The duration is irrelevant to the
Go on with the
Attention 注意
•Refer to the following table for approximate
duration. 37
大致的風乾時間參照下表。 37•The preset during is only for
設定時間僅是風乾的時間,實際運轉時間還要加上理 順衣物和調整衣物平衡的時間,大概要增加 5 至 30 分 鐘。(根據設定時間的變化而改變)。
Operation mode ofSpinningagitating
脫水攪拌•Please prevent the washing machine from shaking when taking out the laundries. (Water may flow out from the injection opening.)
取出衣物時,請勿使洗衣機搖晃。 (水可能會從注入口處流出。)
Press the "START/PAUSE" button . (The sound of buzzer indicates washing completion.)
按下『 L 』 按鈕 。 (蜂鳴聲響起表示洗衣完畢。)
•Please well rearrange the laundries before putting them into the washing basket.
請務必將衣物理順後再放入洗衣槽內。Excessive or
Please pause the operation after the operation failure, reduce the amount of laundry and correct the laundry declination or enwinding,
then press the "START/PAUSE" button . If the failure remains after repeating the above procedure 2 or 3 times, please contact
an authorized service dealer.
出現錯誤後,請暫停運轉,減少衣物量並消除衣物偏斜和纏繞,然後再次按下『 L 』按鈕 。若反復 2 至 3 次仍出現錯 誤,請與認可的維修服務店聯絡。
36