Hitachi AJ-S65KXP, AJ-S70KXP user manual Remove the left water drainage hose cover

Installation Guide (continued)

安裝指南（續）

How to Install the Water Drainage Hose 排水管的安裝(AJ-S70KX)

■The water drainage hose is installed at the factory on the right side. It can be moved to the left side if necessary.

產品出廠時，排水管安裝在機身右側，請視排水位置的具體情況將其換至左側。

1Lay the unit down slowly.

請將機體輕輕地放倒。

•Lay the unit down on some corrugate paper to prevent damage.

放倒機體時，請在地面上放置一些瓦楞紙類的 襯墊，以免損傷機身。

Water drainage hose cover

排水管蓋

Lettering (right)

刻印文字

Water drainage hose is pulled out on the right

固定在排水管引出口（右）處時

2	Pull out the water drainage hose from the left
	side of the unit.
	排水管從左面引出。	Water drainage hose outlet
	1 Remove the left water drainage hose cover.
		排水管引出口

將機體左面的排水管蓋拆下。

2 Inserts in the scoop channel with screwdriver,loosens the hose clamp. 用一字螺絲刀插入凹槽內，鬆開軟管固定夾。

※Advert: the screwdriver please don't bump into the hose. ※注意：螺絲刀請勿碰到軟管。

3After pulling out the end with marking“ ”(right) of the water

drainage hose from the right groove of the unit, the end with		4
marking“	” (left) of the water drainage should be inserted
into the corresponding groove of the left unit.

把排水管刻印文字“ ”(右)標記部從機體右側的凹槽內引出，

刻印文字“ ”（左）標記部應嵌入機體左側對應的凹槽內。

4 The water drainage hose should be pulled out through the proper hosere tainer when the hose is pulled out on the left.

排水管從左面引出時，排水管應通過相應的軟管固定夾後再引出。

Corrugate paper

瓦楞紙

Front

前側

Water drainage hose is pulled out on the left

固定在排水管引出口（左）處時

Water drainage hose cover

排水管蓋

End with making “Left”

刻印文字

Water drainage hose outlet

排水管引出口

4Hose retainer

軟管固定夾

Attention 注意

The“ ”(left) or“ ” (right) mark of the water drainage hose should be inserted into the corresponding groove of the unit.

安裝洗衣機時，請務必將排水管的刻印文字 標記部嵌入機體相對應的凹槽內。

•Water drainage hose which inserts into the unit, can't touch other parts, to prevent the damage caused by water leakage.

排水管在機體內的部分，不應與其他部件碰觸，以免因 破損產生漏水而導致不必要的損失。

•Water drainage hose retainer must be tightened.

排水管固定夾必須夾緊。

•The inner section of the water drainage hose must be secured by the retainer before fetched out.

排水管機內部分必須經固定夾固定後再引出。

■When tting the water drainage hose to the water drainage outlet

排水管插入排水口時

If the water drainage outlet is too shallow or the end of the water drainage hose touches the grounds, cut the end of the water drainage hose in an oblique angle.

排水口較淺或排水管前端與地面碰觸時，可 將排水管的前端沿斜向切除一部分。

• Failure to do so may cause insuf cient	Water drainage hose
rinsing or unit malfunction due to	排水管
poor drainage or too much subbles	Water drainage outlet
during rinsing and spinning.	排水口

若不切除，在漂洗及脫水時，由於排 水狀況的不良，將會引起漂洗不充分 或因肥皂沫而影響電機運轉。

※This discharge pipe installs the method to be only suitable in AJ-S70KX.

此排水管安裝方法只適用於 AJ-S70KX。

10