How to Install the Water Drainage Hose 排水管的安裝(AJ-S70KXP, AJ-S65KXP)
1Connect the water drainage hose with the water drainage joint on the back of the
body.
將排水管連接到机體背後的排水接頭上。
•Fully insert it into place to avoid leakage.
應切實地插入到位，以免漏水。
Water Drainage Hose
2After the connection is completed, please use hose clipper to clamp the water drainage hose to avoid
連接好後，請用軟管夾子將排水管夾緊，以免
脫落。
排水管
Hose Clipper
Water Drainage Joint
排水接頭
軟管夾子
31Insert the fixing holder of water drainage hose into mounting hole.
將排水管固定架插入孔中。
2As shown in illustration, rotate the fixed leg for 90 degree into hole.
按圖示方向旋轉 90 度，將 固定腳旋入孔中。
4Pull the water drainage hose straight, concave to fix into the fixing holder of water drainage hose.
將排水管拉直，嵌入固 定在排水管固定架上。
1m
1Insert |
|
|
插入 |
| Concave |
| Fixing | |
| 嵌入 | |
| holder | |
2Rotate |
| |
排水管 |
| |
旋轉 |
| |
固定架 |
| |
|
|
Unplug
Attention 注意
• To avoid direct draining due to the fallen water drainage hose, the water drainage hose must be used only after installing into fixing holder and its hanging height should not exceed 1m.
為了避免排水管掉落造成直接排水，請務必將排水管嵌入固定架後再進行使用，且排 水管的掛靠高度不應超過 1 米。
•Do not release the water drainage hose lest the water is splashed.
請勿將排水管放倒，以免水洒落。
•Do not use extended water drainage hose.
請勿使用延長排水管。
•Do not immerse the
請勿將排水管尾部的 U 型管浸沒在水中。
•When using it in winter, to prevent icing, please release the water drainage hose after using and place the its tail in water container such as basin, set the washer to single dehydration mode and drain the remained water.
44
在冬季使用時，為防止結冰，使用結束後，請將排水管放倒，並將其尾部放入水盆等 盛水容器，設定洗衣機為單脫水，將殘留的水排乾。 
44
•Be sure not to install the water drainage hose at a position lower than water drainage joint, otherwise, it could lead to difficulties in water drainage.
排水管安裝時，請勿低于排水接頭，如低于排水接頭可能會導致排水不暢。
※This discharge pipe installs the method to be only suitable in
Water drainage hose
排水管
9
