When Failure Happens (continued)
有故障發生時（續）
DISPLAY
Alarm content
警報內容
The lid is not locked
completely
(The lid is not completely closed)
機蓋沒有完全鎖緊
（機蓋沒有完全關閉時）
Washing basket can
not rotate
(washing, rinsing, spinning)
洗衣槽無法旋轉
（洗衣、沖洗、脫水）
Part to check
檢查部位
•Is there foreign substance under
the lid?
機蓋下有異物？
•Are the washings oblique?
衣物有無偏斜？
•Or is the washing machine placed
straight? See page 
8
洗衣機是否水平放置？
8
Solution
處理方法
Troubleshooting
排除異常
Restart operation
再次啟動運轉
Please press the "START/PAUSE" button to pause the operation, rearrange the laundry evenly, and restart with
the lid closed. 請按下暫停按鈕暫 停運轉，調整衣物 平衡後，關閉機蓋 重新啟動。
Lock of lid can not be
unlocked
機蓋緊鎖無法解除
•Press "PAUSE" button, and then
restart it.
按下暫停按鈕，然後重新開機。
If there is still trouble, stop using the unit and contact autho-
rized service centre. 若仍出錯，請停止 使用並聯絡日立維 修服務中心。
The rearranging of laundry is abnormal
衣物抖開異常
(Laundries mixed together cannot separate)
（衣物攪在一起抖不開）
•Is there oblique laundry or mixing-
together during air jet or spinning?
風乾中或脫水中衣物有沒有偏置或攪 在一起？
Press PAUSE button and adjust oblique position, and
then restart.
按暫停按鈕，修整 偏置後關閉機蓋， 重新啟動。
•If the above abnormal alarms occur, they may be caused by outside interference.
若出現上述之外的異常警報，有可能是由外來干擾導致。
•At that time, please press the PAUSE button to suspend the washing machine, then restart it. If the same alarms occur, please stop the use and contact authorized service centre.
此時請按下暫停按鈕暫停運轉，然後重新開機，若仍出現相同的異常警報，請停止使用並聯絡日立維修服務中心。
Before the repair request
要求修理前
Case 現 象
Fail to running
不運轉
Please recheck the following items
請再次檢查以下項目
Cause 原 因
•Is power failure?
是否停電?
•Does fuse or breaker blow?
保險絲或熔斷器是否燒斷？
•Can the power plug enter the socket properly?
電源插頭是否可靠地插入電源插座？
•Is the power switched on?
電源開關是否打開？
•Is the tap turned on?
水龍頭是否打開？
•Is the "Timer washing process" set? 
35
是否設定了預校洗衣程序？
35
•Is the "START" button pressed or not?
有無按下啟動按鈕？
50
2013/10/15 15:12:35
