English
1. Switch operation
Switch
Lock
Hole
Trigger
Switch
Fig. 17
The switch lock is designed to prevent inadvertent operation of the power tool.
To operate the power tool, it is necessary to first push up the switch lock as shown in Fig. 17.
The trigger switch will not operate unless the switch lock has been pushed up. When the trigger switch is released, the power goes off and the switch lock automatically returns to its initial position, locking the trigger switch.
WARNING: This will ensure that the power tool cannot be turned on accidentally or by someone (especially a child) who is not qualified to use the power tool.
To prevent unauthorized operation of this tool, insert a padlock through the hole in the switch trigger.
2. Using the vise assembly (Standard accessory)
Vise
Assembly
Support
Base | 5 mm | |
Clamp Bolt | ||
| ||
| Fig. 18 |
Vise
Assembly
Support
Fence
5mm Clamp Bolt
(1)The vise assembly can be mounted on either the left side base or the right side base, and can be raised or lowered according to the height of the workpiece.
qInsert support of vise assembly into the hole located on either the left side base or the right side base.
wThen tighten 5 mm clamp bolt as shown in Fig. 18.
NOTE: The support has two locking grooves into which the tip of the 5 mm clamp bolt is designed to fit, to lock the vise assembly in the desired position.
(2)The vise assembly can be mounted on either the left side fence or the right side fence, and can be raised or lowered according to the height of the workpiece.
qInsert support of vise assembly into the hole located on either the left side fence or the right side fence.
wThen tighten 5 mm clamp bolt as shown in Fig. 19.
Fig. 19
CAUTION: Always confirm that the motor head (see Fig. 1) does not contact the vise assembly when it is lowered for cutting. If there is any danger that it may do so, loosen the 5
mmclamp bolt slightly and move the vise assembly to a position where it will not contact the saw blade.
15
