Caution | Electric shock or other accidents may cause serious injury or damage to | |
your property. | ||
|
●You must to check the user manual of the computer when you connect to the monitor.
The weight of the monitor or obstructing the ventilation hole of the computer equipment may cause distortion or damage of the computer equipment.
●Disconnect the power plug from the power point when you carry the monitor.
Carrying the monitor without disconnecting the power plug from the power point may damage the cord and cause a fire or electric shock. You are advised to carry the monitor with two persons. Handle with care when you carry the monitor, particularly take care of glass screen.
●When you disconnect the power plug.
You have to grasp the power plug itself, do not pull the power cord.
If you pull the power cord, you may damage it and it may cause a fire or electric shock.
Do not touch the power plug just after disconnecting it from the power point or you may receive an electric shock.
●Disconnect the power plug from the power point when you don't use the monitor for a long time.
This is just for your safety.
●Do not put the monitor in atmosphere with soot, steam, high humidity, and dust.
It may cause a fire or electric shock.
●Do not put the monitor in high temperature atmosphere.
Do not put the monitor in the place exposed to the direct rays of the sun or inside car under the burning sun for a long period of time. Heat may cause a fire, transformation, or melting of the monitor.
●Do not put things on the monitor.
Do not put things on the monitor or give some shock to the monitor.
The monitor may fall down or drop from a desk. And it may cause injury.
Caution | You may have serious injury or your property may be damaged unless | |
you follow the instruction below. | ||
|
●Do not bundle the power cord.
It will be heated up or it may cause a fire.
■Caution for 200 - 240V operation only
This equipment relies on the protective devices in the building installation for short - circuit and over - current protection. Refer to the following table for the suitable number and location of the protective devices which should be provided in the building installation.
INFORMATIVE EXAMPLES OF PROTECTIVE DEVICES IN SINGLE - PHASE
EQUIPMENT OR SUB - ASSEMBLIES
|
| Protection | Minimum number |
|
|
| of fuses or circuit - | Location | |
|
| against | breaker poles |
|
|
|
|
| |
|
|
|
|
|
Case A: | Equipment to be connected to POWER SYSTEMS | Earth faults | 1 | Phase conductor |
| with earthed neutral reliably identified, except for |
|
|
|
| Overcurrent | 1 | Either of the two conductors | |
| Case C below. | |||
Case B: | Equipment to be connected to any supply, including IT | Earth faults | 2 | Both conductors |
| POWER SYSTEMS and supplies with reversible plugs, |
|
|
|
| Overcurrent | 1 | Either of the two conductors | |
| except for Case C below. | |||
Case C: Equipment to be connected to 3 - wire power | Earth faults | 2 | Each phase conductor | |
| systems with earthed neutral reliably identified. | Overcurrent | 2 | Each phase conductor |
|
| |||
|
|
|
|
|
Verify that the protective devices in the building installation meets the conditions in the table prior to installing the equipment.
ENGLISH
■ Remove the power cord for complete isolation!
For complete isolation from the power source, remove the power cord from the monitor or from the wall socket.
5
