Hitachi service manual Disc Access, Disc Almost Full

Troubleshooting > Messages and Troubleshooting

Message	Cause/condition for	Troubleshooting
	message to appear
Data error in all image file.	Appears if writing to file cannot be	Choose “YES” and designate total
Repair all data now?	completed normally because power was	repair (automatic repair) of video file.
YES NO	turned off by mistake during video	Choosing “NO” will display a message
	recording or editing, and it is recognized	for verifying initialization.
	that the video file must be totally	[Refer to *3 page 4-11]
	repaired.
	Also appears when condensation occurs	Do not execute repair, but set the
	on lens or drive of the DVD video	power switch to “POWER OFF” with
	camera/recorder. Condensation will occur	the disc loaded, and then leave the
	when the DVD video camera/recorder is	DVD video camera/recorder in a dry
	moved form a cold place to a warm place.	place until condensation disappears
		(usually 1-2 hours).
DISC ××××	Appears if the self-diagnosis function in	Take note of the 4-digit alpha-
(4-digit alpha-numerals	the DVD video camera/recorder detects a	numerals in ××××, and refer to “4-4
showing the code of trouble	serious problem.	Self-Diagnosis Function and
will appear in ××××.)		Troubelshooting”.
DISC ACCESS	This message appears during normal	Operate the DVD video camera/
	operation process, when the DVD video	recorder after the message
	camera/recorder checks whether a proper	disappears.
	disc has been loaded or not. It is
	displayed for a longer time period when
	the date has changed.
	This message appears during normal	Operate the DVD video camera/
	operation process, when the recorded	recorder after the message
	images are being stored on disc.	disappears.
DISC ALMOST FULL	Appears if the remaining video	Delete unnecessary scenes, or replace
	recordable time on disc is less than 10	the disc.
	minutes, or the remaining number of
	recordable photos is less than 10.
Disc error	Appears when the disc has been edited	Format the disc (deleting all recorded
	on a device other than the DVD video	data), or replace the disc.
	camera/recorder, and mismatch has
	occurred in recorded data.
	Also appears when reading or writing	Clean the disc, or replace it.
	from/to recorded file cannot be performed	[Refer to page 4-11]
	because the disc is dirty.
Disc error has occurred.	Appears when the disc could not be	Clean the disc, or replace it.
Finalizing is not complete.	finalized because it was dirty.	[Refer to page 4-11]
	Appears if accident, such as power off,	Set the power switch to “POWER
	has occurred during finalizing.	OFF” and reconnect the AC adapter/
		charger; then set the power switch to
		“VIDEO” and start finalizing again.
		Or press the DISC EJECT button,
		reload the disc, and then execute
		finalizing.
	If the message still appears even when	Replace the disc.
	the disc has been cleaned and finalized
	again and again, the disc may be
	defective.

4 - 12