Hitachi service manual Power or Connection Error dialog

Adjustment > Creating Reference Data

4)Choose the communication port to which the RS-232C cable is connected, and then choose the radio button of corresponding port on COMMUNICATION PORT SETTING screen.

5)Click the OK button on the COMMUNICATION PORT SETTING screen, and then proceed with the MODEL SELECT screen.

Note:

If the following dialogs appear, perform the troubleshooting below:

POWER OR CONNECTION ERROR dialog

ERROR

MAY OCCURE ON CABLE OR JIG OR CAMCORDER. ! POWER FAILURE OR CONNECTION ERROR!

OK

COM PORT ERROR dialog

ERROR

!COM PORT ERROR

OK

When the power or connection error dialog appears: A connection is incorrect or power is not turned on. Make sure that all connections are correct and that power is supplied to the reference data creating device or DSP-R interface jig.

Clicking the OK button will finish the program: After solving the problem, restart the program.

When the communication port error dialog appears: There was a mistake in selecting communication port. Check the communication port.

Clicking the OK button will finish the program: Select the communication port again after restart.

COMMUNICATION PORT SETTING screen

MANUAL ADJUSTMENT PROGRAM for SERVICE STATION

MANUAL ADJUSTMENT PROGRAM

for SERVICE STATION

COM PORT SETTING

	PORT
	PORT 1	PORT 4
4	PORT 2	PORT 5
	PORT 3	PORT 6

5	OK	EXIT
		Copyright (C) HITACHI, Ltd	2003

6 - 7