Hitachi DZMV100A Attaching Battery to DVD Camcorder, Removing Battery, Battery will discharge

chapter 2_Setups

Cautions

•During and after charging, the battery will be warm, but this does not indicate a fault.

•If the POWER indicator on AC adapter/charger blinks, remove the battery once, and then reattach it. If the POWER indicator still blinks, the battery may be faulty.

•If the ambient temperature is a little too high or low, the CHG. indicator or CHG.80 indicator on AC adapter/charger will blink at 6-second intervals. In this case, charging is possible, but it will take longer than usual.

•If the ambient temperature is too low or too high, the CHG. indicator or CHG.80 indicator on AC adapter/charger will blink at one-second intervals, showing that charging will not be possible.

Attaching Battery to DVD Camcorder

Caution

• Make sure that the battery is securely attached: Incomplete attachment could cause the battery to fall, resulting in damage.

1. Pull out the viewfinder fully and raise it.

1

2. Align the top of battery with the top sur- face of battery attachment platform of DVD camcorder.

3. While fitting the battery onto the DVD 2 · 3

camcorder, slide it downward until a click is heard.

Removing Battery

After using the DVD camcorder, remove the battery from it.

Cautions

•For safety, be sure to turn the DVD camcorder off before attaching or removing the battery.

•If the battery remains attached, minute level current will flow even if the DVD camcorder is off, and

the battery will discharge.

42