Useful Functions during Recording of Movie

Switching Movie Quality Mode.

You can switch the movie quality between "FINE" and "STND".

However, record critical subjects in the "FINE" mode.

Block-like noise may appear in recorded image, or the outline of subject image is distored under the recording conditions listed below: Pan the camcorder as slowly as possible. (Block noise is likely to appear in the "STND" mode):

If there is a complicated pattern (trees, fence, etc.) in background (as in following figure on left)

• If the camcorder is panned or tilted greatly or rapidly

If subject is moving rapidly even when the camcorder is not moving

(Image when block-like noise occurs)

(Image without block-like noise)

1. Press the MENU button in the recording pause status to display the menu screen.

2. Use the Select dial to choose “REC SETUP” and then “V.QUALLTY”.

Options will be next to V. QUALITY: “FINE” is be- ing highlighted.

3.Turn the Select dial to highlight “STND”, and then press the Select dial.

The menu screen for setting record mode will be restored, and “STND” has been specified.

4. Press the MENU button to switch off the menu screen.

77

Page 77
Image 77
Hitachi DZMV100A instruction manual Switching Movie Quality Mode, Press the Menu button to switch off the menu screen