Hitachi HDPJ52 user manual Adjusting the projector’s elevation

Preparations

Adjusting the projector’s elevation

The elevator feet can be used to make adjustments if the surface on which the projector is set is uneven or if the projection angle needs to be otherwise adjusted. The adjustment range of the elevator feet is 0 to 7 degrees.

1. Press and hold in the elevator buttons while holding the projector.

There are elevator buttons and feet	7°
on the both sides of the projector.
Raise or lower the projector to the
2. desired height and release the
elevator buttons. When the elevator
buttons are released, the elevator
feet will lock into position.
If necessary, the elevator feet can
3. be manually twisted to make more
precise adjustments.

WARNING ► Do not adjust the elevation of the projector during or immediately after use. Handling while the projector is hot could cause burn and/or projector malfunction. Before adjusting the elevation, make sure that the power switch is off, that the power cord is unplugged, and that the projector is adequately cool.

CAUTION ► Using the elevator buttons without holding the projector could cause the projector to fall, overturn, or strike your fingers and possibly cause projector malfunction. To prevent damaging the projector and injuring yourself, always hold the projector whenever using the elevator buttons to adjust the elevator feet.

►Do not tilt the projector to the right or left. Also be sure not to raise the front or rear of the projector more than 7 degrees. Raising the projector more than 7 degrees could cause projector malfunction or shorten the lifetime of consumables.

►Other than raising the projector using the elevator feet, place the projector horizontally.

12