17
Cable cover

Connecting the power supply

Preparations

Before connecting the power, make sure that the power switch is in the OFF position (the side marked “O”).

1. Connect the power cord connector to the projector’s AC inlet.

2. Plug the power cord's plug firmly into a power outlet.

Power switch

Power cord connector

ENGLISH

AC inlet

WARNING ► Use extra caution when connecting the power cord as incorrect or faulty connections may result in fire and/or electrical shock.

Use only the power cord that came with the projector. If it becomes damaged, contact your dealer for a new one.

Only plug the power cord into an outlet rated for use with the power cord's specified voltage range.

Never modify the power cord. Never attempt to defeat the ground connection of the three-pronged plug.

The power outlet should be close to the projector and easily accessible.

Do not touch the power cord with wet hands.

Check that the power cord connector is clean (no dust) before using. Use a soft, dry cloth to clean the power cord.

Insert the power plug into the power outlet firmly. Avoid using loose, unsound outlets and contact failures.

Using the cable cover

Use of the accessory cable cover is recommended when the projector is suspended from the ceiling. The cable cover collects the cables together and

prevents slack cables from hanging down

Bottom of the

Screws for cable

from the ceiling.

projector

cover

To attach the cable cover to the projector,

 

 

please use the following procedure.

 

 

1. Loosen the 2 screws on the cable cover and also the screw for the cable cover on the rear of the projector.

2. Attach the cable cover to the projector, bundling the connected cables and running them through the window of the cable cover.

3. Retighten the screws that were loosened in the previous step to lock the cover in place.

Page 17
Image 17
Hitachi HDPJ52 user manual Connecting the power supply, Using the cable cover