Turning the power off

STANDBY/ON

POWER TEMP LAMP

MENU ENTER

INPUT RESET

Projection

 

POWER

LIGHT

ENGLISH

STANDBY/ON button

ASPECT

IRIS

 

BLACK MODE

MEMORY

 

POWER button

ENTER

 

 

BRIGHT CONTRAST COLOR

 

 

MENU

RESET

 

HDMI PC AUTO

COMPO S-VIDEO VIDEO

POWER indicator

1. Press the STANDBY/ON button on the projector or the POWER button on the remote control.

The message "Power off?" will appear on the screen for approximately 5 seconds.

2. Press the STANDBY/ON button on the projector or the POWER button on the remote control again when the “Power off?” message appears.

The projector lamp will go off, and the POWER indicator will begin blinking in orange.

Then the POWER indicator will stop blinking and light steady orange when the lamp is finished cooling down.

POWER off ?

POWER Blinking in orange

POWER Steady orangePOWERSteady orange

3. Make sure that the power indicator is lit a steady orange, and set the power switch to the OFF position.

The POWER indicator will go off.

Do not set the power switch to the OFF position while the POWER indicator is green or blinking.

4. Close the lens cover. For safety purposes, disconnect the power cord if the projector is not to be used for prolonged periods of time.

NOTE • Turn the power off in right order. Turn off the connected devices first and the projector last.

Except for emergencies, whenever you turn the projector off be sure to follow the procedure explained in “Turning off the power”, and do not disconnect the power cord until the procedure is complete. Neglect can cause damage to the electrode and/or prevent the lamp from lighting.

This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly even when turning off the power. If this occurs, please push the restart switch (7, 64) using a pin or similar object. Make sure that the power indicator is lit a steady orange, and set the power switch to the OFF position. Only use the restart switch in exceptional circumstances.

If there is a power failure, or the restart switch is used, allow the projector to cool down for at least 10 minutes before turning on again.

23

Page 23
Image 23
Hitachi HDPJ52 user manual Turning the power off, STANDBY/ON button