Hitachi Koki USA CMP4120HDUS user manual Installation Instructions, Anti-tumble measures

INSTALLATION INSTRUCTIONS

Installation

■To preserve the performance of this product and to maintain safety, always use one

of the special mount units for installation.

Special mount units (options): Wall Mount Unit (horizontal-mount CMPAK04, vertical-mount

		CMPAK14), Ceiling Mount Unit (CMPAT04)
	•	Use one of the special mount units to install this product. A mount of
WARNING		insufficient strength or inadequate design can cause overturning or dropping
		and result in fire, electrical shock or injury. Please note that our company
		assumes absolutely no responsibility for personal injuries or property damage
		caused by use of other mount units or improper installation.
	•	Installation of the wall mount unit and ceiling mount unit can be dangerous,
		so do not attempt this work yourself. Ask your dealer to provide the name of
CAUTIONS	•	a qualified installer.
		In order to prevent an internal temperature increase, maintain a space of
		10cm (4 inches) or more between the sides and other objects such as walls,
		etc., so that the ventilation holes are not blocked.*

ENGLISH

Anti-tumble measures

CAUTION

•Have this unit mounted in a stable place. Take measures to prevent it from tumbling down to avoid possible physical injury.

Securing to a wall or pillar

1)Using a commercially available cord, chain and clamp, secure the set to a firm wall or

10cm (4 inches) or more*

Clamp

pillar.

Securing desktop

1)Using wood screws (two), fasten the set to the clamping screw holes on the rear of the stand as shown.

2)Using commercially available wood screws, secure the set firmly in position.

Cord

or

chain

Wood screw Two places

Using the optional vertical-mount unit (CMPAK14)

Using the optional wall-mount unit (CMPAK14) allows set to mount on wall surfaces as shown at right.

1)Make at least four sets of commercial anchor bolts and screws available to meet various kinds of walls to mount on.

2)Read the instructions supplied with the wall-mount unit carefully to optimally locate the plasma display on a wall surface.

3)Prepare the wall surface for anchoring and drilling as needed, as shown in the sketches.

•Make sure that an adequate wall surface strength and a screw holding strength are available.

Horizontal mounting

Upper left vertical mounting

■ Upper left vertical mounting

Plasma display outline

■Horizontal mounting

Plasma display outline

Driving anchor bolts into a wall surface

Wall surface

Anchor bolt

Hold to 25 mm or below.

CAUTION

•The unit, when mounted, should have the power switch at its bottom. Otherwise, an elevated internal temperature rise could cause the unit to fail or fire.

3