1
2 | Nail Feeder (A) |
Nail Feeder (B) | |
| Nail Stopper |
Nails | 3 |
NAILER OPERATION
Read section titled “SAFETY”(pages 4 – 6).
DANGER
Operators and others in work area MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications.
WARNING
NEVER point tool at yourself or others in work area.
Keep fingers AWAY from trigger when not driving nails to avoid accidental firing.
Choice of triggering method is important. Please read and understand “Methods of Operation” below.
Before starting work, check the nailing operation switching device.
English
This Hitachi nailer includes a nailing operation switching device.
Before starting work, make sure that the switching device is properly set.
If the switching device is not set properly, the nailer will not operate correctly.
Never place your hands or feet closer than 8 inches (200 mm) from firing head when using.
Do not drive nails on top of other nails or with Nailer at too steep of an angle; nails can ricochet and hurt someone.
Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from workpiece and hit someone.
Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a person on the opposite side.
Never use Nailer which is defective or operating abnormally.
Do not use Nailer as hammer.
Disconnect air hose from Nailer when :
1)it is not in use;
2)leaving work area;
3)moving it to another location; and
4)handing it to another person.
This Hitachi nailer is equipped with a nailer operation switching device.
Use SINGLE ACTUATION MECHANISM or CONTACT ACTUATION MECHANISM in accordance with the work to be performed.
A FULL SEQUENTIAL ACTUATION MECHANISM KIT (SEQUENTIAL TRIP MECHANISM KIT) is also available as an option. Part no. 884142.
Explanation of the various nailing operations
SINGLE ACTUATION MECHANISM (SINGLE SEQUENTIAL ACTUATION MECHANISM) : First, press the push lever against the wood; next, pull the trigger to drive the nail.
First, pull the trigger; next, press the push lever against the wood to drive the nail.
After nailing once, nailing will not be possible again until the trigger is released and pressed again.
CONTACT ACTUATION MECHANISM : First, press the push lever against the wood; next, pull the trigger to drive the nail.
First, pull the trigger; next, press the push lever against the wood to drive the nail.
If the trigger is held back, a nail will be driven each time the push lever is pressed against the wood.
FULL SEQUENTIAL ACTUATION MECHANISM : First, press the push lever against the wood; next, pull the trigger to drive the nail. Follow the same sequence to continue driving nails.
— 13 —
