Hobart HFB6 manual Removing And Installing The Top Lamp Shield

REMOVING AND INSTALLING THE TOP LAMP SHIELD

Turn the oven off before removing the lamp shield.

The lamp shields MUST be kept clean to ensure maximum efficiency of the oven. If the lamp shields are dirty, foods may not cook as quickly or as thoroughly as specified in the programmed recipes. The lamp shields should be cleaned any time food or grease begins to build up on the shield surface. Keeping the shields clean will prevent residue from baking on the shields and burning.

The upper lamp shield is easily removed with the door open. Lift the front edge of the lamp shield over the retaining feature (Fig. 2) and pull it toward you.

To reinstall the lamp shield, place it on its rails and gently push it into the oven until it stops. Be sure the lamp shield is properly seated behind the retaining feature.

OVEN DOOR

LAMP SHIELD RAIL

LIFT LAMP SHIELD	UPPER LAMP SHIELD
OVER RETAINING FEATURE
	LOWER LAMP SHIELD
PULL LAMP SHIELD TOWARD YOU
	(NON REMOVABLE)

PL-52646

Fig. 2

It is recommended that you obtain spare lamp shields so that dirty ones can be replaced quickly. Dirty shields can then be cleaned during off-peak times.

The lamp shield is made of a special transparent material with specific properties. Replace shield only with official FlashBake oven replacements.

– 13 –