ERROR MESSAGES
Under certain conditions, the oven will emit a short trill tone alarm when the operator presses a button. This indicates that something is preventing the oven from operating properly. Check the display screen for the following messages:
MESSAGE |
| SUGGESTED ACTION | ||
|
|
|
| |
HIGH POWER IS NOT ON | 1. | Press any button to clear the message. | ||
2. | Restart the cook cycle. | |||
|
|
| ||
| Door detected open after cook cycle started. | |||
[16] DOOR IS OPEN | 1. | Check for obstructions that may be keeping the | ||
| door from closing properly. | |||
|
| |||
| 2. | Restart the cook cycle. | ||
|
|
| ||
| Door detected open at start of cook cycle. | |||
DOOR IS NOT CLOSED | 1. | Check for obstructions that may be keeping the | ||
| door from closing properly. | |||
|
| |||
| 2. | Restart the cook cycle. | ||
|
|
|
| |
| 1. | Press any button to clear the message. | ||
[18] OVEN OVERHEATED | 2. | Make sure the blower is on. | ||
3. | Check vent/duct for obstructions. | |||
ALLOW TO COOL | ||||
4. | Close door, wait for the oven to cool. | |||
| ||||
| 5. | Restart the cook cycle. | ||
|
|
| ||
| An irregular lamp condition was detected. | |||
[15] LAMPS ARE ON *! | 1. | Turn the oven off. | ||
H.V. IS TURNED OFF | 2. | Turn the oven on. | ||
| 3. | Restart the cook cycle. | ||
|
|
|
| |
[19] UPPER LAMP | 1. | Check that the upper lamp shield is properly | ||
| installed. | |||
SHIELD OUT OF PLACE |
| |||
2. | Restart the cook cycle. | |||
| ||||
|
|
|
|
SERVICE
If these actions do not reset the oven and allow the cooking cycle to begin, contact your local Hobart authorized service office.
FORM 34485 (May 2000) | – 16 – | PRINTED IN U.S.A. |