Hobart HQC135, ML-124069, ML-124070, HQC200 manual Soft Chill Editor

•Access the Sys Par 2 menu as shown on page 30.

SYS PAR 1	09:07:31
CLOCK TEMPS IN °F
PROBES	LOGGING
SETUP MENU	MORE	SYS PAR 2		09:08:41
		REMOTE ALARM MODE
		ALARMS		BUZZER
		BACK	FAC PRESETS

MODE

MODE PARAMETERS

CHILL FREEZE

SOFT CHILL

BACK

•From Sys Par 2, select MODE.

•From Mode Parameters, select SOFT CHILL. (BACK returns to SYS PAR 2.)

SOFT CHILL — Assures against freezing by reducing air flow at end of cycle or by increasing air temp.

SOFT CHILL EDITOR
↓BY	TIME	70%↑
←BACK		NEXT→
CANCEL		ENTER
SOFT CHILL EDITOR
↓BY	TEMP	5°F↑
←BACK		NEXT→
CANCEL		ENTER
SOFT CHILL EDITOR
↓2ND	TEMP	28°F↑
←BACK		NEXT→
CANCEL		ENTER

[ % ] x Chill Time = Time when reduced air flow occurs.

Range: [10% to 90% ].

•Set the By Time % using the ↓ or ↑ keys.

•Select NEXT to move to the next field.

[_°F ] + Target Temp = Temp when reduced air flow occurs. Range: [ 5 to 20 °F].

•Set the By Temp degrees using the ↓ or ↑ keys.

•Select NEXT to move to the next field.

(BACK returns to the previous field.)

[ 2nd Temp ] = Sets an alternate Air Temp during the Soft Chill cycle. Range: [ 10°F to 40°F ]. Normal Air Temp (regular chill cycle) = 10°F.

•Set the 2nd Temp degrees using the ↓ or ↑ keys. (NEXT returns to the By Time field.)

•Select ENTER to keep any changes and return to Mode Parameters.

(CANCEL retains the previous settings and returns to Mode Parameters.)

– 36 –