3-10. Installing Wire Spool And Adjusting Hub Tension
Use compression spring with 8 in (200 mm) spools.
Installing 1 Or 2 lb Wire Spool
Spindle
Install these
Spindlecomponents onto spindle.
Order extra spring
Part No. 186 437
Remove these components from spindle.
Tools Needed:
15/16 in
3-11. Changing Input Voltage
2
3
1
4
Tools Needed:
3/8, 7/16 in
When a slight force is needed to turn spool, tension is set.
To install either a 1 lb or 2 lb wire spool, follow the procedure as shown in the illustration.
YTurn Off unit, and disconnect input power.
Unit was shipped from factory set for 230 volts.
1Transformer T1
2Rear Of Power Switch S1
3Lead Marked 230 Volt And Fan Motor Lead
Disconnect 230 volt lead and fan motor lead from rear of S1. Leave fan motor lead connected to 230 volt lead.
4 Lead Marked 200 Volt
Remove cable tie, and slide short piece of sleeving off 200 volt lead, and slide sleeving over end of 230 volt and fan motor leads. Fold sleeving over and secure in place.
Connect 200 volt lead to S1 where 230 volt lead was removed.
Reinstall wrapper.
801
