Hobart Welding Products 250 Connecting To Weld Output Terminals, Installing Work Clamp

3-6. Connecting To Weld Output Terminals

4

	1
			Do not place
			anything between
			weld cable terminal
			and copper bar.
	2
Tools Needed:	3
3/4 in (19 mm)
		Correct Installation
Y Turn off power before connecting to		1	Weld Output Terminal
weld output terminals.		2	Supplied Weld Output Terminal Nut
Y Failure to properly connect weld		3	Weld Cable Terminal
cables may cause excessive heat		4	Copper Bar
and start a fire, or damage your
		Remove supplied nut from weld output ter-
machine.

803 778-A

Incorrect Installation

minal. Slide weld cable terminal onto weld output terminal and secure with nut so that weld cable terminal is tight against copper bar. Do not place anything between weld

cable terminal and copper bar. Make sure that the surfaces of the weld cable terminal and copper bar are clean.

3-7. Installing Work Clamp

1 Work Cable

Route cable out front panel opening from inside.

2

4

1

Tools Needed: 1/2, 3/4 in

2Negative (−/Black) Output Terminal

Connect cable to terminal.

3Hardware

4Work Clamp

Route cable through clamp handle and secure as shown.

Close door.

3

Ref. 802 285-D / Ref. 801 566

OM-192 440 Page 12