Hobart Welding Products OM-945 manual Overload Protection Kohler-Powered Units, Tools Needed

9-4. Overload Protection (Kohler-Powered Units)

Tools Needed: ! Stop engine.

		. If		the	unit is extremely over-
			loaded, weld and generator pow-
			er will stop. Turn unit off and re-
		3/8 in	start		to	reset	the	generator
			protection			circuit and restore
			weld and generator power out-
			put.
			If the rated output of the unit is ex-
			ceeded, engine speed may vary
			rapidly until the weld or generator
			power load is reduced.
		1 Circuit Breaker CB4 (See Parts
	1		List)
		CB4		protects			the	generator
		excitation circuit. If CB4 opens, there
		will be no/low weld and generator
		power output.
		Press button to reset breaker.
		2 Fuse F6 (See Parts List)
		F6 protects the engine wiring
		harness. If F6 opens, the engine
		does not crank. If F6 opens while the
		engine is running, the engine stops.
		Replace fuse if open. Reinstall panel
2		before operating unit.
		.
			If a fuse or circuit breaker opens,
			it usually indicates a more seri-
			ous problem exists. Contact a
			Factory			Authorized		Service
			Agent.

Ref. 801 221-B / Ref. 802 353-G

9-5. Servicing Optional Spark Arrestor (Kohler-Powered Units)

! Stop engine and let cool.

1 Spark Arrestor Screen

Clean and inspect screen. Replace spark arrestor if screen wires are broken or missing.

1

Tools Needed:

1/4 in

Ref. 801 695-A / Ref. 802 339-A

OM-945 Page 35