SECTION 13 − STICK WELDING (SMAW) GUIDELINES
13-1. Stick Welding Procedure
! |
! |
Weld current starts when
electrode touches work- piece.
Weld current can damage
5
4
2
3
6
1 7
electronic parts in vehicles. Disconnect both battery cables before welding on a vehicle. Place work clamp as close to the weld as possible.
1 Workpiece
Make sure workpiece is clean be- fore welding.
2Work Clamp
3Electrode
A small diameter electrode re- quires less current than a large one. Follow electrode manufactur- er’s instructions when setting weld amperage (see Section
4Insulated Electrode Holder
5Electrode Holder Position
6Arc Length
Arc length is the distance from the electrode to the workpiece. A short arc with correct amperage will give a sharp, crackling sound.
7 Slag
Use a chipping hammer and wire brush to remove slag. Remove slag and check weld bead before making another weld pass.
Tools Needed:
stick 2007−04 −
