Hobart Welding Products OM-945 manual Butt Joints, Lap Joint, Tee Joint, Or Less

13-10. Butt Joints

1

2

1/16 in 30° (1.6 mm)

3 4

1 Tack Welds

Prevent edges of joint from draw- ing together ahead of electrode by tack welding the materials in posi- tion before final weld.

2 Square Groove Weld

Good for materials up to 3/16 in (5 mm) thick.

3 Single V-Groove Weld

Good for materials 3/16 − 3/4 in (5-19 mm) thick. Cut bevel with oxyacetylene or plasma cutting equipment. Remove scale from material after cutting. A grinder can also be used to prepare bevels.

Create 30 degree angle of bevel on materials in V-groove welding.

4 Double V-Groove Weld

Good for materials thicker than 3/16 in (5 mm).

S-0662

13-11. Lap Joint

30°	30°
	Or Less
Or Less
1	1

2	3
Single-Layer Fillet Weld	Multi-Layer Fillet Weld

1Electrode

2Single-Layer Fillet Weld Move electrode in circular motion.

3Multi-Layer Fillet Weld

Weld a second layer when a heavi- er fillet is needed. Remove slag be- fore making another weld pass. Weld both sides of joint for maxi- mum strength.

S-0063 / S-0064

13-12. Tee Joint

1

45°

2 Or2 Less

1

1Electrode

2Fillet Weld

Keep arc short and move at defi- nite rate of speed. Hold electrode as shown to provide fusion into the corner. Square edge of the weld surface.

For maximum strength weld both sides of upright section.

3 Multi-Layer Deposits

Weld a second layer when a heavi- er fillet is needed. Use any of the weaving patterns shown in Section 13-9. Remove slag before making another weld pass.

3

S-0060 / S-0058-A / S-0061

OM-945 Page 53