16. Shroud Extender Installation
16.1.The clevis pin holding the shroud to the shroud adjuster must be removed and replaced by the ball lock pin that is part of the shroud extender wire assembly.
16.2.Using the clevis pin removed in #1 above, pin one end of the shroud extender wire assembly to the shroud adjuster. For single handed sailing the shroud tension should be less than that for racing. This is to reduce pressure on the quick release pin so that it may be removed more easily to extend the shroud.
16.3.Attach the other end of the shroud extender wire assembly to the shroud per the drawing. You may have to strip the wire coating in order that the clamp will slide on the shroud.
Note: The final tension of the shrouds and shroud adjustment will vary according to personal preference. Shroud tension must be relieved to lower the mast.
17. FLOAT TOP/ LIFT ASSEMBLY
FIGURE 28
FIGURE 29 | FIGURE 30 |
Slide float shaft into mast & rivet in place.
FIGURE 31
14
