Honeywell 1280i Aimer Delay, User-SpecifiedAimer Delay, Laser Aimer - Good Read Duration, Save, Save, Delay Duration, 10 Segment Line, *Off (no delay), 200 milliseconds

* Laser Aimer - Good Read

10 Segment Line

Laser Aimer - Good Read Duration

Use the Laser Aimer - Good Read Duration bar code to specify how long you want the Laser Aimer - Good Read Pattern to remain on after a bar code has been successfully read. Scan the bar code below, then set the duration (from 0 - 65535 milliseconds) by scanning digits from the inside back cover, then scanning Save. Default = 0 ms.

Laser Aimer - Good Read DurationAimer Delay

The aimer delay allows a delay time for the operator to aim the scanner before the bar code is scanned. Use these codes to set the time between when the trigger is pulled and when the bar code is scanned. During the delay time, the aiming

light will appear, but scanning will not begin until the delay time is over. Default = Off.

200 milliseconds400 milliseconds*Off (no delay)User-Specified Aimer Delay

If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning digits (0 - 4,000 ms) from the Programming Chart inside the back cover of this manual, then scan Save.

Delay Duration

3 - 7