Honeywell 1280i <Default All Code 11 Settings, Code 11 On/Off, Code 11 Redundancy, Check Digits Required, Code 11 Message Length, Save, Code 11 Redundancy

Code 11

<Default All Code 11 Settings>

Code 11 On/Off

On

* Off

Check Digits Required

This option sets whether 1 or 2 check digits are required with Code 11 bar codes. Default = Two Check Digits.

One Check Digit

* Two Check Digits

Code 11 Redundancy

If you are encountering errors when reading Code 11 bar codes, you may want to adjust the redundancy count. Redundancy adjusts the number of times a bar code is decoded before transmission, which may reduce the number of errors. Note that the higher the redundancy count, the longer it will take to decode the bar code. To adjust the redundancy, scan the Code 11 Redundancy bar code below, then scan a redundancy count between 0 and 10 on the Programming Chart inside the back cover of this manual. Then scan the Save bar code. Default = 0.

Code 11 Redundancy

Code 11 Message Length

Scan the bar codes below to change the message length. Refer to Message Length Description (page 6-1)for additional

information. Minimum and Maximum lengths = 1-80. Minimum Default = 3, Maximum Default = 80.

Minimum Message Length

6 - 16