Honeywell 1280i Character Activation Timeout, End Character Activation After Good Read, * Off, Good Read, After Good Read, Character Activation Timeout

End Character Activation After Good Read

After a bar code is successfully detected and read from the scanner, the illumination can be programmed either to remain on and scanning, or to turn off. When End Character Activation After Good Read is enabled, the illumination turns off and stops scanning after a good read. If you scan Do Not End Character Activation After Good Read, the illumination

remains on after a good read. Default = End Character Activation After Good Read.

Do Not End Character ActivationAfter Good Read* End Character Activation AfterGood ReadCharacter Activation Timeout

You can set a timeout for the length of time the illumination remains on and attempting to decode bar codes when using Character Activation Mode. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-65,535 milliseconds) by scanning digits from the Programming Chart inside the back cover of this man- ual, then scanning Save. Default = 5000 ms.

Character Activation Timeout

Character Deactivation Mode

If you have sent a character from the host to trigger the scanner to begin scanning, you can also send a deactivation character to stop scanning. Scan the following On bar code to use character deactivation, then use Deactivation Character (following) to

select the character you will send from the host to terminate scanning. Default = Off.

* Off

On

3 - 13