Honeywell HREP16, HREP4, HREP8 Configuring Buzzer Out Settings, LOW, MODE, TYPE, HIGH, Note, ALARM, APPLY, MOTION, LATCHED, LATCHED, DURATION, ALARM OUT, OPERATION, HDD EVENT, VIDEO LOSS

Installation

2.Configure the following behavior settings:

ALARM OUT	Choose to configure a specific alarm output.
OPERATION	Enable/disable the selected alarm output.
MODE	Select from TRANSPARENT (the output is active only when the
	trigger criteria are present) or LATCHED (the output is active for
	a set period of time after a trigger).
DURATION	In LATCHED mode, this is the time that the alarm output remains
	active after it has been triggered.
TYPE	Select from HIGH (0V to +5V when activated) or LOW (+5V to 0V
	when activated).
HDD EVENT	Determines whether a hard drive event triggers the alarm output.

3.Configure the following action settings:

ALARM	Configure whether the alarm inputs trigger the alarm output.
VIDEO LOSS	Configure whether video loss on any of the selected channels
	triggers the alarm output.
MOTION	Configure whether motion detection on any of the selected
	channel triggers the alarm output.

Note Remember to select APPLY and click to save all settings before exiting these menus.

Configuring Buzzer Out Settings

1.Click BUZZER OUT on the left side of the EVENT/SENSOR window. The BUZZER OUT setup menu appears.

60