HREP Color Digital Video Recorder User Guide

3.Configure the SIZE, FPS, QUALITY, and AUDIO for each channel. Click to save a setting. Click to cancel a setting and exit that setting.

Table 2-4 Configurations for Continuous/Motion RecordingConfiguration Description
SIZE

Select recording resolutions of 352x240, 704x240, or 704x460

 

(NTSC) can be selected for each channel.

 

 

FPS

Frame rates between 1 and 30 can be set for each channel.

 

 

QUALITY

Four different picture recording qualities can be set for each

 

channel.

 

 

AUDIO

If audio devices are connected to the DVR, you can turn the audio

 

recording ON/OFF. Any audio channel can be assigned to any of

 

the video channels. Please refer to your camera’s setup menu.

 

During playback, when a particular channel is selected in full

 

screen, the assigned audio channel plays back at the same time.

 

 

4.Select OK, then press to save your settings. Press or navigate to CANCEL then press to exit without saving the changes.

When configuring 16 channels, the channels are divided into two groups of 8.

Note The maximum recording frame rate for each group is 240FPS at a resolution of 1 CIF (352x240).

Four channels can be recorded in full D1 (4CIF@704x480) resolution, with a maximum of 2 two channels from each group.

Note Remember that if the SCHEDULE MODE is set to WEEKLY, then the recording settings should be changed for each day as well as for each particular time.

Note This DVR supports a maximum recording rate across all channels of 480 frames per second at 352x240 resolution. As the settings are adjusted, the “frames available” at the bottom left displays the number of available frames still remaining and must always be zero or higher. See Configuring SIZE/FPS/QUALITY Window on page 66.

If, while changing recording settings, this figure becomes negative, then the recording resolutions and/or frame rates must be lowered to increase the “frames available” value to zero or above.

Document 800-06847 Rev B

67

08/10