REMOTE THERMO HYGROMETER SENSOR
FEATURES
•Remote data transmission to the main unit via 433 MHz signal
•328 feet (100 meters) operating range without interference
•LCD displays temperature, humidity and channel
•Five (5) transmission channels selection
•Case can be wall mounted using
A.LED INDICATOR
•Flashes once when the remote sensor transmits a reading to the main unit.
•Flashes twice when battery power is low.
B.BATTERY COMPARTMENT
Holds two
C. RESET
Resets all previous settings
D. CHANNEL SWITCH
Selects the desired channel from 1 to 5
E.
Keeps the remote sensor on the wall
Note: Install the batteries and select the channel before mounting the sensor.
BATTERY INSTALLATION
•Remove the screws from the battery compartment with a small Phillips screwdriver.
•Set the channel 1 through 5. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote sensor is being used.
•Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery compartment.
•Replace the battery compartment door and secure the screws.
•Secure the
MOUNTING
•The remote
7
mounted on the wall in vertical position
•Use the wall mount hardware and screws provided when mounting the
PLACEMENT
•The remote
•Ideally, place the
•Avoid placing the
•Avoid any areas collecting and radiating a heat from the sun, such as metal, brick or concrete structures, paving, patios and decks.
•The international standard for the valid air temperature measurements is 4 feet (1.25meters) above the ground.
OPERATION
Immediately after batteries are correctly installed, the remote sensor will start transmitting a temperature and humidity data to the main unit.
RAIN GAUGE
FEATURES
•Precipitation measurement
•Remote transmission of the rainfall data to the main unit via 433 MHz signal
•Operating range of up to 100 feet (30 meters)
•
•
BA
C
A. Rain gauge bucket
Holds all rain gauge components
B.Knob
Secures the top on the rain gauge bucket
8