Honeywell TN924W Weather Station Controls Panel, Set, Channel, Mem, History, Alarm/Chart

WEATHER STATION CONTROLS PANEL

A. UP	Selects the next available mode clockwise
	Increases parameters
	Activates manual search for atomic time signal
	Enables or disables time alarms (W) and (S) and Ice
	Warning Alarm
B. DOWN	Selects the next available mode anti-clockwise
	Decreases parameters
	Activates manual search for signals from the remote
	weather sensors when depressed and held for 5 sec.
C. SET	Toggles display between different modes
	If depressed and held, activates programming mode or
	changes unit of selected parameter
	Confirms programmed parameters
D. CHANNEL	Recalls a different temperature and humidity channel
	from 1 to 5
	Activates the remote temperature and humidity channels
	auto-scan feature
E. MEM	Allows displaying the memory records of the moon
	phase, temperature, humidity, rainfall and wind data
	If depressed and held, clears memory of collected
	records
	Activates a searching mode of the sunrise and sunset
	history records
F. HISTORY	Allows displaying the SEA LEVEL pressure history
G. ALARM/CHART	Allows displaying all available alarms – for time,
	temperature, rainfall and wind.
	If depressed and hold, allows entering into the alarm
	programming mode for selected parameter
	When depressed and hold in pressure/forecast mode,
	allows viewing of the temperature and humidity history
	charts

PLACEMENT

•For best Weather Radio reception place the main unit where it can receive NWS signals and you can hear the weather broadcast – do not place it near

17

any large obstructions or surfaces such as refrigerators, metal cabinets, etc

•For best Weather Station reception make sure that the main unit is locating within the operating range of all remote weather sensors

•Ideally the remote weather sensors should be mounted within the line of sight from the main unit

•Transmission range may be affected by trees, metal structures and electronic appliances

•Test reception before permanently mounting all remote weather sensors Avoid placing the main unit in the following areas:

•Direct sunlight and surfaces emitting and radiating heat, such as heating ducts or air conditioners

•Areas with interference from the wireless devices (such as cordless phones, radio headsets, baby listening devices) and electronic appliances

OPERATION

Once the main unit is powered, the Weather Station display will show all available LCD segments for 2 seconds.

The Weather Radio display line will remain blank for 2 seconds, then SIGNAL LOSS statement with RF reception symbol will appear and radio will start scanning through all 7 NOAA channels. If the reception is successful, it will detect and lock on the available channel.

IMPORTANT: All of the Weather Station display functions will be locked, allowing setting pressure parameters and local altitude. The locked display will show the pressure icon and abbreviation “inHg” flashing in Pressure Window, indoor temperature and humidity readings in Temperature/Humidity Window, default time in Time Window and a default sunset/sunrise time in the Sunrise/Sunset Window.

If pressure and altitude are not configured during this time, the Weather Station will self-calibrate in a few minutes and show the default settings for the pressure and altitude (sea level) and then all remote weather sensors readings.

To set the pressure & altitude units and program your altitude, use the main unit control panel, located on the back.

NOTE: When adjusting altitude in feet or meters, be noted that the last small digit is not a decimal but a whole number.

Example: “350” feet means 350 feet (three hundred fifty feet).

18