Searching for the signals from the remote sensor
Corresponding remote sensor signal received
successfully
No signals received for over 15 minutes
ALL REMOTE SENSORS SIGNAL ACTIVATION
The main unit can be manually activated to search for the signals from remote sensors by pressing and holding DOWN button.
WIND WINDOW
The left section of the Wind Window can be programmed to display either a temperature at the place of anemometer or the temperature adjusted to the wind chill factor.
The right section of the Wind Window indicates the average wind speed for the past 10 minutes, as well as gust, high wind speed and gust alarm information. It can also show records of the maximum wind speed and wind gust collected during the day.
The wind speed and gust can be programmed to alert you if the wind speed or gust exceeds a
ACCESSING
Press UP or DOWN until the WIND icon 
on the display starts flashing.
OPERATING
In the Wind Window press the SET button to recall:
•Wind chill temperature with wind speed
35
•Temperature at anemometer with wind speed
PROGRAMMING UNITS
In the Wind Window, press and hold SET to set the wind speed units in km/h, mph, m/s or knots.
VIEWING STATISTICS
In the Wind Window, press the MEM button to recall:
•Current wind speed, a daily maximum wind speed with “DAILY MAX” displayed, a gust speed with a “GUST” displayed and a daily maximum gust speed with a “GUST DAILY MAX” displayed.
RESETTING STATISTICS MEMORY
In the Wind Window, press and hold MEM to reset all wind statistics.
ACTIVATING OR DEACTIVATING ALARMS
In the Wind Window press ALARM to recall
•Current wind speed
•Wind speed alarm with the “ALARM HI” displayed
•Wind gust alarm with the “GUST ALARM HI” displayed
•Daily maximum wind speed with “DAILY MAX” displayed
If the specific alarm is disabled, “OFF” will be displayed; otherwise the alarm value will be shown.
When the wind alarm is displayed, press the UP or DOWN to activate or deactivate it.
PROGRAMMING HIGH WIND ALARM
•In the Wind Window, press ALARM to select the desired alarm (wind
3536
