speed or wind gust speed)
•Press and hold ALARM button until speed digit will flash.
•Set the alarm using the UP or DOWN. Press and hold either button for fast digits advance.
•Press ALARM to confirm your selection and return to the high wind alarm selection screen.
Never use any abrasive cleaning agents and solvents. Do not immerse any units with electronic parts in water or under running water.
WIND METER
Check if the wind cups can spin freely and are free from dirt, debris and spider webs.
TROUBLESHOOTING
Check here before contacting customer service.
MAINTANANCE
CHANGING BATTERIES
The battery status of each weather sensor is checked every hour. If the low battery indicator lights up, replace the batteries in the corresponding unit.
CHANGING BATTERIES IN THE MAIN UNIT
•Remove the battery compartment door from the back and replace batteries. Do not mix old and new batteries
•Replace the battery compartment door
CHANGING BATTERIES IN REMOTE SENSORS
•Replace the batteries following the setup instructions for the corresponding sensor
•When the batteries are properly installed, the remote weather sensor will resume sending signals to the main unit
•To enforce an immediate remote signals search, press and hold DOWN on the main unit
Issue
Main unit
Main unit
Remote sensor
Symptom
US Atomic Time signal is not received
The weather readings weather station are different from the TV, radio or official weather reports
Cannot locate remote sensor
Cannot change the channel
Cannot change the C° to F° and back
Data does not match data on the main unit
Solution
Place unit by the window and keep it there overnight
The weather data may vary considerably due to different environmental conditions and placement.
Check the placement tips included in this manual to site your weather sensors in the best possible way.
Check batteries
Check location
Press and hold DOWN ( ▼) button on the main unit to search for the signal form the remote sensor
Press “RESET” after setting the channel
Press “RESET” after setting C/F
Initiate manual sensor search (Press and hold DOWN ( ▼) button on the main unit)
CLEANING
The main unit and outer casings of the remote weather sensors can be cleaned with a damp cloth. Small parts can be cleaned with a cotton tip or
37
PRECAUTIONS
This product is engineered to give you years of satisfactory service if handled carefully. Here are a few precautions:
•Do not immerse the units in water.
3738
