Honeywell TE852W, TS815, TE852ELW Activating Or Deactivating Snooze, To disable time alarms

•Press ALARM to confirm selection

•Set the alarm minutes using UP or DOWN. Press and hold either button for quick digit advance.

•Press ALARM to confirm selection – the snooze interval digits will flash

•Set a Snooze interval (all three alarms share the same snooze time duration) using UP or DOWN. Press and hold either button for quick digit advance.

•Press ALARM to confirm selection.

After programming is completed, the display will return to the alarm selection screen.

Note: Ice Warning Alarm (PRE-AL) cannot be set if weekday alarm (W) or single alarm(S) is not enabled.

ACTIVATING OR DEACTIVATING SNOOZE

To enable a snooze function press LIGHT/SNOOZE button.

Note: Alarm will automatically enter the snooze mode if no buttons are pressed after the alarm sounds for 2 minutes. This will occur for a maximum of three times.

To disable time alarm(s):

Press ALARM entering into the specific alarm mode and press ALARM again to disable this alarm.

Note: For weekday (W) alarm, pressing ALARM will only disable the alarm for the current day. The alarm will activate again on the next day, Monday through Friday.

WWVB RADIO CONTROLLED TIME

The NIST (National Institute of Standards and Technology) radio station (WWVB) is located in Ft. Collins, Colorado. It transmits an exact time signal

27

continuously throughout the most of the continental United States at 60 KHz frequency. The Atomic Time Clock in your weather station can receive this WWVB signal through the internal antenna from up to 2,000 miles away. Due to the nature of the Earth’s ionosphere, reception can be limited during the daylight hours. The radio controlled clock will search for an alternate station that receives the atomic time signal from the NIST Atomic clock in Boulder, Colorado.

The WWVB tower icon on the unit’s display will flash indicating a radio signal reception from the WWVB station. If the tower icon is not fully lit, or if the time and date are not set automatically, please consider the following:

•During night-time hours, atmospheric disturbances are typically less severe and radio signal reception may improve. A single daily reception is sufficient enough to keep the clock accuracy within 1 second.

•Make sure the unit is positioned at 8 feet (2 meters) distance from any interference source such as a TV, computer monitor, microwave, etc.

•Within concrete wall rooms such as basements or office buildings, the received signal may be weakened. Always place the Projection Clock near the window for better reception.

Once the atomic time signal is received, the date and time will be set automatically, and the [] icon will appear.

After the clock is set manually, place the main unit by the window for the better reception. The atomic clock receiver is programmed that it will continue to search for the atomic time signal daily for every hour between 1:00 am and 4:30 am.

Once the time signal has been successfully received, the time and date will be updated automatically.

To enable or disable the atomic time receiver:

•Press and hold UP - if atomic time reception is activated, a triangular

2728