THE GAS BURNERS
Burner cap
Burner head | Pan support |
•Burner caps and pan supports : the pan support is made of enamelled
The use of abrasive cleansers is not recommended as they scratch and dull the enamel.
•The burner head : the burner cap is simply placed on the burner head. If the holes are clogged, brush the caps using soapy water and dry with a clean cloth.
Each burner is simply layed on a flange slightly bossed to drain the overflows far from the flame and the hot areas which make cleaning easier.
•After cleaning of each element, it is important to wipe them correctly and care of fitting them rightly in their initial position. The
Warning : be careful, not to let any water get into the burners.
THE KNOBS
•For thorough cleaning, the control knobs can be removed by pulling them upwards. Only clean with soapy water and dry well before replacing them.
•Do not try to pull the watertightness rings. They are originally fitted and must not be pulled out.
15