Hoover 33800316, 3380032, 33800315 manual Installation, Before installing the hob, For installation

INSTALLATION

Installing a domestic appliance can be a complicated operation which if not carried out correctly, can seriously affect consumer safety.

It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in accordance with the technical regulations in force.

In the event that this advice is ignored and the installation is carried out by an unqualified person, the society declines all responsibility for any technical failure of the product whether or not it results in damage to goods or injury to individuals.

￿Before installing the hob :

￿make sure that the appliance is compatible with the gas supply source.

The hob is pre-set in the factory to work with the type of gas shown on the packing and the plate attached to it.

Natural gas G 20-20 mbar / G 25-25 mbar : mains gas

￿if necessary, adapt the hob for use with another type of gas : if the hob must be used with another type of gas than the gas pre-set in the factory, it is necessary to adapt the hob gas burners (page 5).

The procedure for adaptation consists of :

. fitting the correct jets to ensure nominal delivery.

￿For installation,

￿built-in hob (page 6).

￿make the gas connection according to the type of gas to be used : based on the gas to be used, choose the appropriate gas connection (page 7).

￿make the hob electrical connection according to the instructions (page 8).

￿adjusting the minimum flame of the taps : if necessary, adjust the minimum flame of the taps by turning the by-pass screw (page 9).

All modification concerning the hob gas setting must be indicated on the rating plate of the hob.

4