Horizon Fitness AT1501 manual Conditioning Guidelines

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

ASSEMBLY STEP 4

HARDWARE BAG 4 CONTENTS:
	BOLT (H)	BOLT (C)	WASHER (I)	WAVY WASHER (J)
	20 mm	16 mm	34 mm	23 mm
	Qty: 8	Qty: 2	Qty: 2	Qty: 2

ASSEMBLY STEP 4:

LEFT UPPER	HANDLEBAR SHAFT
HANDLEBAR

WAVY WASHER (J)

REAR MAST COVER

ASSEMBLY STEP 5

HARDWARE BAG 5 CONTENTS:

BOLT (C)	WASHER (L)
16 mm	18 mm
Qty: 4	Qty: 4

ASSEMBLY STEP 5:

WATER BOTTLE HOLDER

CONSOLE

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BOLTS (H)

RIGHT UPPER HANDLEBAR

BOLTS (C) WASHER (L)

BEFORE ASCENT TRAINER YOU BEGIN OPERATION

BOLT (C)	WASHER (I)
	BOLT (C)
WASHER (I)
	BOLTS (H)
	RIGHT LOWER
	HANDLEBAR
LEFT LOWER
HANDLEBAR

STEP E DIAGRAM

PRE-ATTACHED BOLTS

CONSOLE MAST

BOLTS (C) WASHER (L)

MAIN FRAME BRACKET

ASCENT TRAINER BEFORE OPERATION YOU BEGIN

CONDITIONING GUIDELINES &

MAIN FRAME

A Open HARDWARE BAG 4.

WASHER (I) BOLT (C)

A Open HARDWARE BAG 5.

B	Run wires from MAIN FRAME BRACKET through the CONSOLE MAST.
C	Attach CONSOLE MAST to the MAIN FRAME BRACKET using 4 BOLTS (C) and 4 WASHERS (L).

CONDITIONING GUIDELINES

TROUBLESHOOTING LIMITED

MAINTENANCE WARRANTY

10

BSlide 1 WAVY WASHER (J) onto each HANDLEBAR SHAFT.

CSlide the LEFT LOWER HANDLEBAR onto the HANDLEBAR SHAFT. Be sure the LEFT LOWER HANDLEBAR is positioned the same as shown in the diagram.

DSlide the LEFT UPPER HANDLEBAR onto the HANDLEBAR SHAFT. Using 4 BOLTS (H) connect the UPPER and LOWER HANDLEBAR as shown in the diagram. Do not tighten any bolts until all 4 are started.

ESecure the handlebar assembly using 1 WASHER (I) and 1 BOLT (C).

FRepeat STEPS C-E on the opposite side.

NOTE: Be sure to attach WASHER (I) as shown in STEP E DIAGRAM.

D	Attach wires to back of CONSOLE.
	NOTE: Do not pinch wires.
E	Attach CONSOLE to the CONSOLE MAST using 4 PRE-ATTACHED BOLTS.
F	Slide WATER BOTTLE HOLDER into back of CONSOLE.

11

LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE

AT1501_Rev.2.6.indd 10-11 7/31/08 12:43:34 PM