INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

ELLIPTICAL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

10

A S S E M B LY STEP 4

 

PEDAL ARM

 

PEDAL ARM COVER

SCREW (J)

SCREW (K)

 

ROLLER WHEEL COVER

 

A)Open HARDWARE BAG FOR STEP 4.

B)Attach the PEDAL ARM COVER using 1 SCREW (J).

C)Attach the ROLLER WHEEL COVER using 1 SCREW (K).

D)Repeat on other side.

HARDWARE BAG FOR STEP 4 CONTENTS :

SCREW (J)

SCREW (K)

15 mm

12 mm

Qty: 2

Qty: 2

A S S E M B LY STEP 5

 

CONSOLE MAST

 

PRE-ATTACHED BOLTS

 

AND WASHERS

UPPER HANDLEBAR

 

 

PRE-ATTACHED SCREWS

LOWER HANDLEBAR

 

NOTE: There is NO hardware bag for this step. All hardware is pre-attached.

A)Remove PRE-ATTACHED BOLTS and WASHERS from CONSOLE MAST.

B)Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting PRE-ATTACHED BOLT and WASHERS.

C)Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR

D)Slide right UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET SCREWS

E)Repeat on other side.

After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.

11

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

H-series_E5_Rev.1.2.indd 10-11

6/16/08 2:40:13 PM

Page 6
Image 6
Horizon Fitness E5 manual Remove PRE-ATTACHED Bolts and Washers from Console Mast