BEFORE
YOU BEGIN
8
INTRODUCTION IMPORTANT
PRECAUTIONS ASSEMBLY BEFORE
YOU BEGIN ELLIPTICAL
OPERATION LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY STEP 2
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
MAIN FRAME
CONSOLE MAST
TOP COVER
WATER BOTTLE HOLDER
PRE-ATTACHED
SCREWS
A) Open HARDWARE BAG FOR STEP 2.
B)
Carefully slide the
TOP COvER
up over the
CONSOLE MAST.
C)
Carefully pull the CONSOLE WIRES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
D) Attach the CONSOLE MAST to the MAIN FRAME using 7 BOLTS (B), 7 SPRING WASHERS (C) and
7 FLAT WASHERS (D).
E) Slide the TOP COvER down onto the MAIN FRAME.
F)
Attach the
WATER BOTTLE HOLDER
to the
CONSOLE MAST
using 2
PRE-ATTACHED SCREWS
.
HARDWARE BAG FOR STEP 2 CONTENTS :
BOLT (B)
SPRING WASHER (C)
FLAT WASHER (D)
MAIN FRAME
CONSOLE MAST
TOP COVER
WATER BOTTLE HOLDER
PRE-ATTACHED
SCREWS
ASSEMBLY STEP 3
LOWER HANDLEBAR
CONSOLE MAST
PRE-ATTACHED
BOLT & WASHER
A) There is no hardware bag for this step.
B) Remove PRE-ATTACHED BOLTS & WASHERS from CONSOLE MASTS.
C) Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by using PRE-ATTACHED BOLTS & WASHERS.
Reminder: The upper and lower handlebars are marked with an L if they are to be used on the left-hand side
of the elliptical or an R if they are to be used on the right-hand side of the elliptical. If the handlebars are
assembled on the incorrect side of the elliptical, the unit will not function correctly.
After handlebars are assembled they will rotate freely – be cautious. Until the
machine is fully assembled, do not grab the handlebars for support.
WARNING
SXE7.7_Rev.1.6.indd 8-9 8/16/07 11:01:12 AM