Horizon Fitness SXE 7.7 manual Conditioning Guidelines

INTRODUCTION IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

A S S E M B LY STEP 4

BOLT (F) FLAT WASHER (G)

FLAT WASHER (E)

PEDAL ARM

SPACER (H)

LINK ARM AXLE

LOWER LINK ARM

PEDAL ARM

A S S E M B LY STEP 5
SPACER (O)	TEFLON WASHER (I)
		LOWER HANDLEBAR
LOWER LINK ARM			OUTSIDE
		INSIDE ELBOW COVER	ELBOW COVER
STEP B
LOWER LINK ARM	LOWER	NUT (L)
	HANDLEBAR		BOLT (J)
TEFLON WASHER (I)		LOWER LINK ARM
	SPACER (O)
		SCREWS (N)
STEP C		STEPS D-G

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

CONDITIONING GUIDELINES &

A) Open HARDWARE BAG FOR STEP 4.

B)Align the LINK ARM AXLE on the LEFT LOWER LINK ARM with the RIGHT PEDAL ARM.

C)Slide the SPACER (H) through the LINK ARM AXLE and the PEDAL ARM until it can no longer rotate.

D)Insert 2 FLAT WASHERS (G) between the PEDAL ARM and the LINK ARM AXLE.

E)Secure the joint with a FLAT WASHER (E) and BOLT (F).

F)Repeat on the other side.

A)Open HARDWARE BAG FOR STEP 5.

B)Slide SPACER (O) into LOWER LINK ARM.

C)Place 2 TEFLON WASHERS (I) on both sides of SPACER (O). While holding TEFLON WASHERS (I), slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.

D)Insert 1 BOLT (J) into LOWER HANDLEBAR and secure using 1 NUT (L).

E)Repeat on other side.

F)Attach the INSIDE and OUTSIDE ELBOW COVERS to the right LOWER LINK ARM using 2 SCREWS (N).

G)Repeat on other side.

Confirm that the

LOWER HANDLEBAR

and the LOWER LINK ARM

are marked R. The left side is marked L.

ELLIPTICAL OPERATION

CONDITIONING GUIDELINES

TROUBLESHOOTING LIMITED

MAINTENANCE WARRANTY

10

HARDWARE BAG FOR STEP 4 CONTENTS :

FLAT WASHER (G) 28.4 mm

Qty: 4

FLAT WASHER (E)

35mm Qty: 2

BOLT (F)

15mm Qty: 2

SPACER (H) Qty: 2

HARDWARE BAG FOR STEP 5 CONTENTS :

	SPACER (O)
	Qty: 2
BOLT (J)	NUT (L)
45 mm	8 mm
Qty: 2	Qty: 2

TEFLON WASHER (I) 24 mm

Qty: 4

SCREW (N) 12 mm Qty: 4

11

LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE

SXE7.7_Rev.1.6.indd 10-11 8/16/07 11:01:24 AM