11.REMOVAL AND REPLACEMENT OF THERMISTOR CAUTION
1.Fragile, handle very carefully.
2.Always use a recommended sealant (High Thermal Conductive Type), Model KE4560RTV manufactured by SHINETSU SILICONE,
Part Code
3.Always use a recommended foam insulation
1)Turn off the power supply.
2)Remove the panels.
3)Remove the Control Box Cover.
4)Disconnect the Thermistor leads from
the K3 Connector on the Controller Board.
5)Remove the Plastic Cable Ties, Foam Insulation, Thermistor Holder and Thermistor. See Fig. 2.
Thermistor Lead | Cable Tie |
Foam Insulation | Thermistor Holder |
6) Scrape away the old sealant on the | Fig. 2 |
Thermistor Holder and the Suction Pipe. |
|
7)Wipe off moisture or condensation on the Suction Pipe.
8)Smoothly apply recommended sealant (KE4560RTV, Part Code
9)Attach the new Thermistor to the Suction Pipe very carefully to prevent damage to the leads. And secure it using the Thermistor Holder and recommended foam insulation.
10)Secure the insulation using the Plastic Cable Ties.
11)Connect the Thermistor leads through the bushing of the Control Box to the K3 Connector on the Controller Board.
Note: Do not cut the leads of the Thermistor while installing it.
12) Replace the Control Box Cover and the panels in their correct positions.
13) Turn on the power supply. | 46 |
|