Tailgate Seal Replacement, Front View | Marathon RJ-88SC, RJ-250VL

2 MAINTENANCE

TAILGATE SEAL REPLACEMENT	2-7

When the door/tailgate seal becomes damaged or worn, replace the seal.

WARNING: For units with hydraulic tailgates, before performing any inspection or maintenance on the seal, support the raised tailgate with a crane, forklift, or other positive maintenance prop.

•WHEN REMOVING THE OLD SEALS (TOP & BOTTOM), MARK THE POSITION OF THE SEAL JOINTS. PRY THE SEAL RETAINER UP SLIGHTLY TO ALLOW REMOVAL OF THE OLD SEALS.

•WHEN INSTALLING THE NEW SEALS, JOIN THE SEALS AT THE SAME POSITIONS.

A

FRONT VIEW -

DOOR SEAL ON DOOR

A

NEW SEAL

PRY BAR

NEW SEAL

SEAL RETAINER - PRY SLIGHTLY UPWARD SO NEW SEAL CAN BE INSERTED

SECTION A-A

USE A PLASTIC OR RUBBER HAMMER TO TAMP THE SEAL RETAINER SNUG AGAINST THE SEAL ALL THE WAY AROUND THE SEAL(S)

Image 20

Marathon RJ-88SC, RJ-250VL, RJ-100SC, RJ-250SC Tailgate Seal Replacement, Front View, Door Seal on Door, Section A-A

Contents

Play IT Safe Contents Operation Introduction Wastec SpecificationsSide View PRE-OPERATION Instructions Only Authorized Personnel Should be Allowed Inside Keyed Start Switch Reverse Operator StationEmergency Stop Control Description for 88SC, 100SC, & 250SC Control Description for 250VL Case of Emergency Operating Instructions for RJ-250VL Manual Override Instructions RAM Stop Rear only RJ-250VL Optional Controls Decals for RJ-88SC, RJ-100SC, RJ-250SC, or RJ-250VL Remote Power Unit Optional Loading Configurations Dock Access Gate & HopperTHRU-THE-WALL Security Chute Hydraulic Tailgate HT Units Rear View Maintenance LOCK-OUT & TAG-OUT Instructions Periodic Maintenance Procedures Pressure SettingPressure Settings Relief Setting RAM Control Timer Adjustment Printe D Circuit Board Locate D I N Motor Control Panel MULTI-CYCLE Timer Adjustment Option Warranty and Service on MotorsCylinder Removal Instructions RAM Stop Forward Option Standard System Operating CHARACTERISTICS, 5 hp & 10 hp Principles of Operation Tailgate Seal Replacement Front ViewDoor Seal on Door Section A-A Fuses and Circuit Breakers ChartsTimer Settings Wire Sizes Length Size Parts List Part Description Motor Control Panel Typical Power Unit Standard 5 HP Power Unit Standard 10 HP Hydraulic Schematic Typical TROUBLE-SHOOTING Chart Problem Cause Solution Pump Makes NOISE-SOUNDS Container Guides Concrete PAD RequirementsConcrete PAD Steel Installation Procedures Dock InstallationCHUTE-FED Installation Decals Electrical & Hydraulic Installation Remote Power Pack Installation START-UP Instructions Pushbutton Operator StationElectrical Connections TOP View Compactor THROUGH-THE-WALL Power Unit InstallationPower Unit Hauler Instructions General See the Next page for Door and Latch Operation Instructions Latch Side View Container Hauler Instructions DOOR/LATCH OperationAuto Relatch For Optional HT Units Instructions for Using Maintenance BAR Body Between the Tailgate and the Container Hauler Instructions Liquid Removal For Optional SL Units