3 INSTALLATION
ELECTRICAL & HYDRAULIC INSTALLATION | |
|
|
PUSHBUTTON OPERATOR STATION
If a remote operator station is furnished, it will be factory wired using Sealtite. If it is necessary to disconnect it from the wires (to install the operator station inside a build- ing), exercise care that these wires are reconnected as originally furnished. (Check local codes to be certain that Sealtite is acceptable.)
CAUTION: Operator Station must be located so that the Mushroom (Emergency) Stop Button is readily accessible to the operator and within three (3) feet of the charging chamber access door. If installation requires this operator station to be located in a more remote area, a second Emergency Stop Button should be added and installed in the manner described above.
ELECTRICAL CONNECTIONS
1.Run power lines, between fused disconnect switch (customer furnished) and com- pactor's motor control panel, in accordance with local electrical codes, using knock- outs in bottom of motor control panel. See Fuse & Circuit Breaker Chart for Motors and Wire Size Chart, in the Maintenance Section, to determine the proper service disconnect amperage rating and the proper wire size.
NOTE: High legs should be installed to L3 on motor starter.
2.Check voltage at fused disconnect switch to be certain it is the same as is shown on compactor or remote power pack. If voltage is correct, put fused disconnect switch in "ON" position.
START-UP INSTRUCTIONS
1.With the ram fully retracted, check to be sure the oil reservoir is full to the 3/4 level on the sight gauge (Refer to the maintenance chart for hydraulic oil recommenda- tions). The hydraulic system pressure has been factory set and the entire unit has been operated prior to shipment.
2.CAUTION: MAKE SURE PERSONS AND MATERIAL ARE CLEAR OF CHARGE BOX AREA.
3.Depress the start button and check the pump shaft for proper rotation.
CAUTION: If the pump rotates backward, stop immediately. The pump will be damaged if it is operated in reverse even for short periods. Reversing any two incoming power lines will change the motor/pump rotation.
4.Make sure that the operators are trained in the proper use of this equip- ment.
