Hotpoint CSX27C warranty Ice & Chilled Water Dkpemer, Before Using Your Icemaker and Dispenser

Ice & Chilled Water Dkpemer

Automatic Icemaker and Ice & Water Dispemer

Your refrigerator has an automatic icemaker and a dispenser that dispenses chilled water and ice cubes through the freezer compartment door. Here’s how they work.

Water flows from the household supply through a

(1)dual solenoid valve to the

(2)water reservoir and to the

(3)automatic icemaker as needed.

Water is frozen in the

(4)cube mold and ejected into the

(5)storage bin where a motor- powered auger moves cubes forward into the dispensing unit.

When you touch the CUBED pad on front of freezer compartment door, ice cubes will dispense through chute in door when cradle is pressed.

When you touch the CRUSHED pad, baffle in housing channels cubes through the crusher and crushed ice falls through chute into glass when cradle is pressed.

Chilled water from reservoir flows through the

(6)tubing in the door and is dispensed when the cradle is pressed.

(7)A light switch turns the night light in the dispenser on or off when the LIGHT pad is touched.

Important Fac@ about Your Ice &Water Dispenser

●Your icemaker will produce eight cubes per cycle-approximately 120 cubes in a 24-hour period– depending on freezer compartment temperature, room temperature, number of door openings and other use conditions.

●Intermittent dispensing of ice is normal. If ice flow interruption is more than brief, ice clump(s) may be the cause and should be removed following instructions below and on page 130

c Avoid overfilling glasses with ice and wing narrow or extra-till glasses. This can jam the chute or cause the door in the chute to freeze shut. Periodically open the freezer compartment door and look down into the chute. If ice is blocking the chute, poke it through with a wooden spoon.

●To help keep bits of ice from being sprayed beyond the glass, place glass close to ice chute— but not so close that it blocks outcoming ice.

●Ice should not be dispensed into thin glasses, fine china or delicate crysti-they can crack or chip from the combined pressure of your hand pressing them against the cradle and ice dropping into the container.

●Ice should be dispensed before filling glass with soda or other beverage mixes. This will prevent splashing which is annoying and which, if the splash reaches the ice and water selector switch, could cause it to stick or bind.

●Beverages and foods should not be quickwhilled in the ice storage bin. Cans, bottles or food packages in the storage bin may cause the icemaker to malfunction.

●Ice other than that produced by your icemaker should not be added to the ice storage bin—it may not crush or dispense well.

Before Using Your Icemaker and Dispenser

If you use your refrigerator before the water connection is made, raise the ice access door and make sure the icemaker feeler arm is in the OFF (up) position as shown below.

MIce access

Idoor

Icemaker

->

.K “

When water supply has been connected to icemaker, move feeler arm to ON (down) position.

Depress water dispenser cradle for about two minutes to remove trapped air from water line and to fill water reservoir automatically.

Ice cube mold automatically fills with water after cooling to freezing temperatures. First cubes normally freeze after several hours.

N~E: With a newly-installed refrigerator, allow about 24 hours for the freezer compartment to cool down to the proper icemaking temperature.

(continul’dnext pug(’)