To Remove Dmwers
1.Remove food from the shelf above the Sealed and Fresh drawer and take out the shelf. Take food off the glass cover and out of the drawer.
2.Put your fingers behind the gasket at the rear of the drawer and pull forward. Remove the gasket.
3.Pull thedrawer partway out. Reach in, push the rear of the glass up; at the same time, push it back until it clears
4.Tilt and remove the cover.
\,
..<
\
/‘“’
5.Pull thedrawer forward. Iiftthe front to clear stops, and remove the drawer. If the refrigerator door doesn’t open completely, pull the drawer out until it hits the door. Then lift the drawer up until it is higher than the drawer supports, tilt it and take it out.
6.Iftape holds Convertible Meat Pan co~er to drawer supports, remove the tape. Pull drawer partway out. Reach in, push the rear of the glass up and, at the same time, back, until it clears
7. Tilt and remove the cover.
8. Tilt and remove the drawer.
After cleaning, replace in reverse order.
\
When drawers and covers are back in place, reinstall the gasket at the rear of the Sealed and Fresh drawer. Fit the end of the plastic drawer support into the slot on the gasket, with the rubber gasket flap facing you. Make sure the gasket snaps into place.
17
